Foam pipe insulation

  • Foam pipe insulation
  • Foam pipe insulation

Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest
INQUIRY

Foam pipe insulation

Foam-pipe-insulation-1

(Rubber insulation pipe)

Foam pipe insulation  is a high flame-retardant polyethylene foam products, the petrochemical industry, construction industry and refrigeration industry ideal for cold storage project.

Foam pipe insulation common product specifications: For 54mm \ 41mm \28mm \22mm \16mm copper pipe.

Advantage:

 

1.Environmental protection: Does not contain atmospheric harmful chlorofluorocarbons, ISO14000 international environmental certification requirements, so in the installation and application will not produce harmful substances

2.Insulation efficiency: Foam rubber is a high-quality energy-saving insulation materials, is cold and heat insulation anti-condensation nemesis, low thermal conductivity and stability.

3.Flame Retardant: Foam rubber and plastics materials meet the standard GB8624, B1 grade flame retardant material after testing.

4.Smooth appearance: Foam pipe insulation with high elasticity, smooth surface, soft texture, even installed in the elbow, three links, valves and other accessories can remain intact and beautiful.

5.Easy to install, fast: As the material is soft, for pipe installation, pipe installation schedule can be put together, but also the rubber pipe cut open and then use a special glue from the glue can be.

Foam pipe insulation installation should pay attention to the following points:
1 all the cut, joints are required to use a special glue seal.
2 after installation, all three links, elbows, valves, flanges and other accessories are required to meet the design thickness.
3 Do not glue too much force when gluing, the interface between all materials should be glued slightly under pressure.
4 the installation should be after the first small tube, elbow, after the three straight, the last valve, flange.
5 when installing chilled water pipes and refrigeration equipment, both ends of the rubber and plastic pipe and the gap between the iron pipe are required to be coated with glue to glue, adhesive width should not be equal to the thickness of rubber material.
6 the pipeline cut mouth should try to install in inconspicuous place, and the two pipe cutting gap should be staggered.
7 Do not install the machine in use. Do not power on within 36 hours of installation.
8 large diameter rubber tube packaging has become oval because of the relationship, cut open when you cross more flat side.

Share on FacebookTweet about this on TwitterShare on LinkedInShare on Google+Pin on Pinterest

Leave a Reply

Your email address will not be published. Required fields are marked *

Chat with us
Chat with us
Questions, doubts, issues? We're here to help you!
Connecting...
None of our operators are available at the moment. Please, try again later.
Our operators are busy. Please try again later
:
:
:
Have you got question? Write to us!
:
:
This chat session has ended
Was this conversation useful? Vote this chat session.
Good Bad